Forschungsdaten – Titel und Zusammenfassungen von Publikationen, extrahierte Daten und Katalogeinträge – erscheinen in ihrer Originalsprache Englisch.
Comparative study between synthetic and dairy wastewaters in single chamber microbial fuel cell for power generation
Payel Choudhury, Ria Majumdar, Tarun Kanti Bandyopadhyaya
KI-Zusammenfassung
65 % KonfidenzThis paper optimizes synthetic wastewater composition for a single-chamber MFC using Pseudomonas aeruginosa, achieving 485 mV with 1.5% lactose, 0.3% ammonium chloride, 0.03% NaCl, 3% inoculum, 37°C, and pH 7. Real dairy wastewater (COD 801 mg/L) generated 561 mV and 73.54 mW/m² power density. The work is primarily a power-generation study with minimal focus on nitrogen cycling, speciation, or electrochemical operating windows relevant to bioelectrochemical nitrogen management.
Zentrale Erkenntnisse
Schwellenwert Ammonium chloride concentration above 0.3% decreased voltage generation, indicating a threshold inhibition effect at higher nitrogen loading.
Was heißt das. Operators should not exceed 0.3% ammonium chloride in synthetic media; higher N loading does not improve performance and may inhibit exoelectrogenic activity.
Schwellenwert Lactose concentration above 1.5% suppressed voltage (410 mV at 1% vs 485 mV at 1.5%), suggesting substrate inhibition or catabolite repression at high carbon levels.
Was heißt das. Maintain C/N ratio near the optimized 1.5%/0.3% ratio; excess carbon does not translate to higher power and may inhibit enzyme synthesis.
Leistung Real dairy wastewater (561 mV, 73.54 mW/m²) outperformed optimized synthetic medium (485 mV) despite similar pH and temperature, indicating complex organic composition enhances exoelectrogenic performance.
Was heißt das. Real wastewaters contain co-substrates or cofactors absent in simple synthetic media; design MES for complex feeds rather than pure glucose/lactose.
Schwellenwert Voltage remained stable for 168 hours (120–288 h) then declined, indicating substrate depletion or biofilm maturation limits batch operation duration.
Was heißt das. Batch MFC operation is limited to ~5–12 days; continuous or fed-batch operation needed for sustained power; monitor voltage plateau as indicator of substrate exhaustion.
Ansatzpunkte6
Konkrete Lücken in dieser Publikation, jeweils mit einem Experiment, das sie schließen würde.
Hoch No measurement of nitrogen speciation (NO₃⁻, NO₂⁻, NH₄⁺, N₂O, N₂) in effluent or over time; ammonium chloride input fate is unknown.
Paper states 0.3% NH₄Cl is optimal but provides no data on whether N is assimilated, oxidized, or released; critical for nitrogen cycling assessment in MES context.
Versuch. Measure NH₄⁺, NO₃⁻, NO₂⁻ in catholyte and anode chamber at 24, 72, 168, 360 h; use ¹⁵N-labeled NH₄Cl to track N fate.
Hoch No cathode potential, anode potential, or cell voltage control; only open-circuit voltage (OCV) and external resistance variation reported.
Paper measures OCV and polarization curves but does not report electrode potentials or operate at fixed potentials; cannot assess denitrification or nitrification windows.
Versuch. Operate at fixed cathode potentials (−0.4 to −0.8 V vs Ag/AgCl) and anode potentials (−0.2 to +0.4 V) to map N reduction/oxidation activity.
Hoch No dissolved oxygen (DO) measurement or control; single-chamber design implies anaerobic anode but cathode DO status unknown.
Nitrogen cycling (nitrification vs denitrification) is DO-dependent; paper does not report cathode DO or aeration strategy, limiting interpretation of N transformations.
Versuch. Measure DO in cathode chamber; test aerated vs non-aerated cathode; correlate DO with N speciation in effluent.
Hoch No investigation of N₂O accumulation or N₂ production; only power and voltage reported.
Single-chamber MFC with lactose and ammonium could favor denitrification intermediates; N₂O is a potent greenhouse gas and indicator of incomplete denitrification.
Versuch. Measure N₂O and N₂ in headspace by GC-MS; vary cathode potential and C/N ratio to identify N₂O accumulation risk.
Mittel C/N ratio fixed at 1.5%/0.3% (5:1 by mass, ~50:1 molar); no systematic variation of C/N to assess nitrogen limitation or excess.
Paper optimizes each parameter independently but does not explore C/N trade-offs; optimal ratio for power may differ from optimal for nitrogen recovery or denitrification.
Versuch. Vary C/N ratio from 10:1 to 100:1 (molar); measure power, voltage, and N speciation in effluent.
Mittel Catholyte pH not reported; only bulk medium pH 7 stated; cathode pH can drift during operation and affects nitrification/denitrification kinetics.
Nitrogen cycling is pH-sensitive; paper does not monitor or control catholyte pH, which can shift due to proton consumption/generation at cathode.
Versuch. Monitor catholyte pH continuously; test fixed pH control (6.5–8.5) and measure impact on N speciation and power output.
Erstellt von der MESSAI-Extraktionspipeline · mit dem Quell-PDF abgleichen
Literatur-Priors
Was gemacht wurde
- Systemtyp
- MFC
Was funktioniert hat
Zusammenfassung
To investigate the performance of microbial fuel cell (MFC) with a single-chamber membrane, Pseudomonas aeruginosa is used as a bio catalyst for various synthetic wastewaters rich in carbohydrate and is compared with real dairy wastewater in this experiment. Therefore, the choice of appropriate carbon, nitrogen, NaCl, inoculum content, temperature, and pH process parameters are used for preparing synthetic wastewater was agreed upon by one-variable-at-a time approach. Maximum levels of voltage generation attained from the synthetic wastewater was 485 mV when supplemented with 1.5 % of lactose as a source of carbon, 0.3 % of ammonium chloride as a decent nitrogen source, 0.03 % of NaCl, inoculum concentration of 3 %, the temperature at 37 °C and pH 7. On the other hand, the maximum voltage attained with real dairy wastewater was 561 mV with high chemical oxygen demand (COD) value of 801 mg l⁻¹. The maximum power density obtained from dairy wastewater was 73.54 mW m⁻². Thus, High voltage achieved for MFC operating with real dairy wastewater suggests that it can be used not only for the industrial application to generate more renewable power, but also for the wastewater treatment carried out at the same time.
Schlagwörter
Kennungen
- Zeitschrift
- Journal of Electrochemical Science and Engineering
- Jahr
- 2021
Repräsentatives Modell: MFC – zugeordnet nur anhand des Systemtyps der Publikation, nicht ihres Reaktors oder ihrer Geometrie.
Berichtete Parameter
Der in der Publikation berichtete Wert (▼) ist auf der Literaturverteilung aus MESS-Parameters eingezeichnet. Werte außerhalb des Bands werden als Ausreißer gekennzeichnet.
26 extrahierte Werte
Extrahierte Werte ansehenÖffnen Sie das Modell im Labor, um alle Steuerelemente, die Parameterbearbeitung und Vorlagen-Overlays zu nutzen.
Im Labor öffnen →