Forschungsdaten – Titel und Zusammenfassungen von Publikationen, extrahierte Daten und Katalogeinträge – erscheinen in ihrer Originalsprache Englisch.
A revolving algae biofilm based photosynthetic microbial fuel cell for simultaneous energy recovery, pollutants removal, and algae production
Huichao Zhang, Qian Yan, Zhongyi An, Zhiyou Wen
KI-Zusammenfassung
78 % KonfidenzThis paper describes a membrane-free photosynthetic microbial fuel cell (RAB-MFC) using a revolving algae biofilm cathode for simultaneous wastewater treatment and electricity generation. The system achieved 93.5% COD removal in the anode and 95.8% in the cathode, with ammonia removal efficiency of 91.1% (anode) and 98.0% (cathode), corresponding to an ammonia removal rate of 0.92 mg/L/h. Maximum power density reached 33.1 mW/m² at 2,400 mg/L COD influent. The work demonstrates that algal biofilm cathodes can replace expensive platinum catalysts and ion-exchange membranes while maintaining pollutant removal performance.
Zentrale Erkenntnisse
Zielkonflikt Increasing influent COD from 1,200 to 2,400 mg/L did not significantly change voltage at 1,000 Ω external resistance, but significantly increased voltage at 2,000 Ω (P < 0.05), revealing a resistance-dependent response to organic loading.
Was heißt das. Operators should match external load resistance to the system's internal resistance (400 Ω here) to maximize power output across varying COD concentrations; fixed-load operation may mask performance gains.
Schwellenwert Higher influent COD (2,400 mg/L) caused biofilm color change from green to brown after four feeding cycles, indicating bacterial takeover and loss of algal dominance despite maintained COD removal.
Was heißt das. Maintain influent COD ≤1,200 mg/L to preserve algal dominance and oxygen production; higher organic loading selects for heterotrophic bacteria that may reduce long-term cathode performance.
Mechanismus Ammonia removal rate in RAB-MFC (0.92 ± 0.02 mg/L/h) exceeded that of standalone RAB system (0.64 ± 0.12 mg/L/h), indicating electrochemical coupling enhances nitrogen removal kinetics.
Was heißt das. Integrate electrochemical driving force into algal biofilm systems to accelerate ammonia removal; the 44% rate increase suggests electron transfer or pH gradients enhance nitrification or assimilation.
Mechanismus Nitrate accumulated in cathode effluent (11.0 ± 0.85 mg/L from 1.46 mg/L influent) while ammonia was removed, indicating net nitrification rather than complete denitrification or assimilation.
Was heißt das. If complete nitrogen removal is required, add a denitrification stage or operate cathode under anoxic conditions; current aerobic cathode favors nitrification over denitrification.
Leistung Open-circuit voltage (OCV) of RAB-MFC (695–700 mV) was 22% higher than H-type MFC with suspended algae (570 mV), attributed to elevated cathode potential from biofilm-based oxygen production.
Was heißt das. Immobilized biofilm cathodes generate higher thermodynamic potential than suspended cultures; prioritize biofilm engineering over increasing anode potential for voltage gains.
Widersprüche1
Nur Konflikte, die die Publikation selbst zeigt, jeweils am Text geprüft.
Innerhalb der Publikation Biofilm color change and bacterial takeover occur despite maintained high COD removal at 2,400 mg/L.
Eine SeiteCOD removal rate reached 95% in the cathode chamber at 2,400 mg/L COD
“As influent COD increased to 2,400 mg/L, the COD removal rate reached 95% in the cathode chamber”
Andere SeiteThe color of the biofilm on the cathode surface changed to light brown, indicating the takeover of bacteria in the microbial consortium, and continuous operation was stopped
“The continuous operation of the RAB-MFC system at this influent COD level was stopped when the color of the biofilm on the cathode surface changed to light brown, indicating the takeover of bacteria”
Einordnung der Autoren. Authors attribute biofilm shift to COD stress but do not quantify whether COD removal efficiency actually declined; they stopped operation preemptively based on visual indicator rather than performance loss, suggesting the two metrics (removal efficiency vs. community composition) decouple at high organic loading.
Ansatzpunkte6
Konkrete Lücken in dieser Publikation, jeweils mit einem Experiment, das sie schließen würde.
Hoch No measurement of N2O or NO2- accumulation during nitrification; only NO3-N and NH4-N tracked.
Cathode operates aerobically with high ammonia removal (98%) and net nitrate accumulation (11 mg/L), creating conditions favorable for N2O production, but no gas-phase analysis reported.
Versuch. Measure N2O and NO2- in cathode effluent and headspace across COD 1,200–2,400 mg/L and HRT 6–7 days; quantify N balance to close nitrogen fate.
Hoch No systematic variation of cathode potential or current density to map nitrification vs. denitrification trade-off.
Paper reports nitrification (NO3-N accumulation) but does not test whether lower cathode potential or higher current density would favor denitrification or N2O reduction.
Versuch. Vary external resistance (10–10 kΩ) or apply controlled cathode potential (−0.2 to +0.4 V vs. Ag/AgCl) and measure NO3-N, NO2-N, and N2O production; identify operating window for complete nitrogen removal.
Mittel Catholyte pH not reported; only anode and cathode effluent pH shown in Figure 6B without values.
Nitrification and denitrification are pH-sensitive; cathode biofilm likely generates local pH gradients that affect nitrogen speciation and removal pathways.
Versuch. Monitor pH in cathode biofilm microenvironment and bulk catholyte; correlate with ammonia removal rate and nitrate accumulation across 1,200–2,400 mg/L COD.
Mittel No dissolved oxygen (DO) measurement in cathode chamber; oxygen production rate by algae not quantified.
Algal oxygen production is the limiting factor for cathode performance, but DO is not tracked; unclear whether oxygen is saturating or limiting at different COD levels.
Versuch. Measure DO in cathode liquid phase and biofilm during light/dark cycles at 1,200 and 2,400 mg/L COD; correlate with current density and nitrification rate.
Mittel Membrane-free design allows oxygen diffusion from cathode to anode, but no quantification of oxygen leakage or its impact on anode potential.
Authors acknowledge 'part of the electrons in anode chamber can be consumed by oxygen diffused from the cathode chamber' but provide no data on oxygen crossover or anode potential loss.
Versuch. Measure anode potential under anaerobic vs. aerobic conditions; vary hole diameter and number to quantify oxygen diffusion rate and its effect on coulombic efficiency.
Mittel C/N ratio of influent not explicitly controlled or varied; only COD and ammonia concentrations reported.
Nitrogen removal efficiency may depend on C/N ratio; paper tests two COD levels but does not systematically vary ammonia concentration or C/N ratio.
Versuch. Test C/N ratios from 5:1 to 20:1 (by varying NH4Cl while holding COD constant) and measure ammonia removal rate, nitrate accumulation, and algal growth.
Erstellt von der MESSAI-Extraktionspipeline · mit dem Quell-PDF abgleichen
Was gemacht wurde
- Systemtyp
- MSC
Was funktioniert hat
Zusammenfassung
Photosynthetic microbial fuel cell (PMFC) based on algal cathode can integrate of wastewater treatment with microalgal biomass production. However, both the traditional suspended algae and the immobilized algae cathode systems have the problems of high cost caused by Pt catalyst and ion-exchange membrane. In this work, a new equipment for membrane-free PMFC is reported based on the optimization of the most expensive MFC components: the separator and the cathode. Using a revolving algae-bacteria biofilm cathode in a photosynthetic membrane-free microbial fuel cell (RAB-MFC) can obtain pollutants removal and algal biomass production as well as electrons generation. The highest chemical oxygen demand (COD) removal rates of the anode and cathode chambers reached 93.5 ± 2.6% and 95.8% ± 0.8%, respectively. The ammonia removal efficiency in anode and cathode chambers was 91.1 ± 1.3% and 98.0 ± 0.6%, respectively, corresponding to an ammonia removal rate of 0.92 ± 0.02 mg/L/h. The maximum current density and power density were 136.1 mA/m² and 33.1 mW/m². The average biomass production of algae biofilm was higher than 30 g/m². The 18S rDNA sequencing analysis the eukaryotic community and revealed high operational taxonomic units (OTUs) of Chlorophyta (44.43%) was dominant phyla with low COD level, while Ciliophora (54.36%) replaced Chlorophyta as the dominant phyla when COD increased. 16S rDNA high-throughput sequencing revealed that biofilms on the cathode contained a variety of prokaryote taxa, including Proteobacteria, Bacteroidota, Firmicutes, while there was only 0.23–0.26% photosynthesizing prokaryote found in the cathode biofilm. Collectively, this work demonstrated that RAB can be used as a bio-cathode in PMFC for pollutants removal from wastewater as well as electricity generation.
Schlagwörter
Kennungen
- Zeitschrift
- Frontiers in Microbiology
- Jahr
- 2022
Dieser Publikation ist noch kein 3D-Modell zugeordnet. Die Parameterbereiche oben ordnen die berichteten Werte trotzdem in die Literaturverteilung ein.