Electrogenic Bacteria Enhance the Structure and Performance of Nitrite-Reducing Electroactive Biofilms

Konkrete Lücken in dieser Publikation, jeweils mit einem Experiment, das sie schließen würde.

• Hoch No evaluation of N₂O accumulation or selectivity toward N₂ vs NO₂⁻ accumulation during RPBC nitrite reduction across the tested potentials (−0.4 to −0.2 V).

  Paper focuses on nitrite removal rate and electroactivity but does not report N₂O or NO₂⁻ as products; denitrification selectivity is critical for environmental compliance and energy efficiency.

  Versuch. Measure gas headspace (N₂O, N₂) and liquid-phase NO₂⁻ at −0.4, −0.3, −0.2 V during 12 h chronoamperometry; determine if more positive potentials favor complete denitrification or cause nitrite accumulation.

• Hoch No investigation of cathode potential effect on long-term stability or electrogenic bacteria retention after polarity reversal; only −0.4 V tested in MFC/MEC stability experiments.

  Section 3.3 shows −0.3 V is optimal for enrichment, but Section 3.3 (MFC/MEC mode) only uses −0.4 V for stability testing; unclear if −0.3 V biofilms maintain performance or if electrogenic bacteria wash out.

  Versuch. Culture RPBC biofilms at −0.3 V to maturity, then operate in MFC mode (no external potential) or MEC mode at −0.3 V for 30+ days; measure reducing electroactivity and Geobacter abundance over time.

• Mittel No systematic study of C/N ratio or organic substrate type (only acetate tested) on interspecies electron transfer efficiency and nitrite-reducing EAB selectivity.

  Paper varies acetate concentration (100–1500 mg COD L⁻¹) but fixes nitrite at 30 mgN L⁻¹; C/N ratio ranges from 3.3 to 50 but is not explicitly analyzed. Different substrates (formate, ethanol, glucose) may alter Geobacter metabolism and electron transfer kinetics.

  Versuch. Test C/N ratios 5, 10, 20, 50 at fixed −0.3 V; vary substrate (formate, ethanol, propionate) and measure Geobacter growth rate, electron transfer efficiency (via CV), and nitrite removal selectivity.

• Mittel No measurement of dissolved oxygen (DO) or pH in the working electrode chamber during RPBC; potential for unintended aerobic or microaerobic conditions affecting electrogenic bacteria metabolism.

  Methods state 'flushed with pure N₂ for 20 min' but do not report residual DO or pH drift during 6-day culture; electrogenic bacteria (Geobacter) are strict anaerobes, and pH changes affect electron transfer kinetics.

  Versuch. Monitor DO (optical sensor) and pH continuously during RPBC at −0.3 V; correlate with electroactivity curves; test if active pH buffering or sparging improves reproducibility.

• Mittel Metronidazole treatment (MFC-1, MFC-2, MFC-3 experiments) may not completely eliminate electrogenic bacteria; no confirmation of Geobacter kill or residual metabolic activity post-treatment.

  Section 2.3 and Table 1 describe metronidazole soaking but do not report CFU counts, qPCR, or FISH confirmation of Geobacter elimination; residual electrogenic bacteria could confound interpretation of long-term stability results.

  Versuch. Perform qPCR (Geobacter-specific primers) and FISH on biofilms before and after metronidazole treatment; confirm >99% reduction in electrogenic bacteria abundance before MFC-1/2/3 operation.

• Mittel No direct measurement of interspecies electron transfer rate or nanowire/pili abundance; mechanism inferred only from electroactivity correlation and biofilm composition.

  Paper claims 'interspecies electron transfer' but provides no direct evidence (e.g., electron transfer resistance, nanowire density via TEM, or metabolite exchange rates); FISH and SEM show biofilm structure but not electron transfer pathways.

  Versuch. Use electrochemical impedance spectroscopy (EIS) to measure charge transfer resistance; perform TEM on biofilm cross-sections to quantify nanowire density; measure formate/acetate gradients across biofilm depth.