Forschungsdaten – Titel und Zusammenfassungen von Publikationen, extrahierte Daten und Katalogeinträge – erscheinen in ihrer Originalsprache Englisch.

KI-Zusammenfassung

100 % Konfidenz

MFC research in electrode, membrane. In order to study the performance and bacterial communities of an anaerobic fluidized bed mi...

Erstellt von der MESSAI-Extraktionspipeline · mit dem Quell-PDF abgleichen

Was gemacht wurde

Systemtyp
MFC

Was funktioniert hat

Noch keine Ergebniskennzahlen extrahiert.

Zusammenfassung

In order to study the performance and bacterial communities of an anaerobic fluidized bed microbial fuel cell (AFB-MFC) system, the 16S rDNA gene sequencing was applied, and high-strength synthetic wastewater was treated by the AFB-MFC system. The high-strength synthetic wastewater, in which the concentrations of chemical oxygen demand (COD), nitrite nitrogen, and nitrate nitrogen were above 19,000, 2,516–3,871 and 927–1,427 mg/L, was treated by the AFB-MFC system. The removal efficiency of COD, nitrite nitrogen, and nitrate nitrogen reached 70–89, 98 and 98%, while the maximum voltage was 394 mV. The bacteria analysis revealed the presence of Alistipes putredinis, Carnobacterium sp., Victivallis vadensis, Klebsiella pneumoniae, Thauera sp., Parabacteroides merdae, Parvimonas micra, Parabacteroides sp., and Desulfomicrobium baculatum in the anode chamber. In addition, the Klebsiella pneumoniae was observed to have the capability of organic degradation and electricity generation, while the Thauera sp. has the capability of denitrification.

Schlagwörter

Microbial fuel cellWastewaterChemical oxygen demandDenitrificationNitriteNitrate

Kennungen

Zeitschrift
Water Science and Technology
Jahr
2014
Generische MFCRepräsentatives Modell
Klicken, um die Strömung zu animieren
3D-Modell wird geladen …

Repräsentatives Modell: MFC – zugeordnet nur anhand des Systemtyps der Publikation, nicht ihres Reaktors oder ihrer Geometrie.

Extraktion

Berichtete Parameter

Öffnen Sie das Modell im Labor, um alle Steuerelemente, die Parameterbearbeitung und Vorlagen-Overlays zu nutzen.

Im Labor öffnen →