Forschungsdaten – Titel und Zusammenfassungen von Publikationen, extrahierte Daten und Katalogeinträge – erscheinen in ihrer Originalsprache Englisch.

Was gemacht wurde

Systemtyp
MFC

Was funktioniert hat

Noch keine Ergebniskennzahlen extrahiert.

Zusammenfassung

A poorly understood phenomenon with a potentially significant impact on electron recovery is competition in microbial fuel cells (MFC) between anode-respiring bacteria and microorganisms that use other electron acceptors. Nitrate is a constituent of different wastewaters and can act as a competing electron acceptor in the anode. Studies investigating the impact of competition on population dynamics in mixed communities in the anode are lacking. Here, we investigated the impact of nitrate at different C/N ratios of 1.8, 3.7, and 7.4 mg C/mg N on the electrochemical performance and the biofilm community in mixed-culture chemostat MFCs. The electrochemical performance of the MFC was not affected under electron donor non-limiting conditions, 7.4 mg C/mg N. At lower C/N, electron donor limiting and ratio electron recovery were significantly affected. The electrochemical performance recovered upon removal of nitrate at 3.7 mg C/mg N but did not at 1.8 mg C/mg N. Microbial community analysis showed a decrease in Deltaproteobacteria accompanied by an increase in Betaproteobacteria in response to nitrate at low C/N ratios and no significant changes at 7.4 mg C/mg N. Transcriptional analysis showed increased transcription of nirK and nirS genes during nitrate flux, suggesting that denitrification to N 2 and not facultative nitrate reduction by Geobacter spp. might be the primary response to perturbation with nitrate.

Schlagwörter

NitrateMicrobial fuel cellChemostatElectron acceptorDenitrificationDeltaproteobacteria

Kennungen

PubMed
28374997
Zeitschrift
Environmental Science & Technology
Jahr
2017
Generische MFCRepräsentatives Modell
Klicken, um die Strömung zu animieren
3D-Modell wird geladen …

Repräsentatives Modell: MFC – zugeordnet nur anhand des Systemtyps der Publikation, nicht ihres Reaktors oder ihrer Geometrie.

Extraktion

Berichtete Parameter

Aus dieser Publikation wurden noch keine Werte extrahiert.

Öffnen Sie das Modell im Labor, um alle Steuerelemente, die Parameterbearbeitung und Vorlagen-Overlays zu nutzen.

Im Labor öffnen →